The images in your store come from three places: your product photos, the logo and landing image in Settings, then General, and the artwork the Studio draws where there is no photo yet. You replace an image where it is set. Uqail cannot put a photo you send in the chat into your store.
Start from the preview
- In the Studio, press "Select" on the dock under the preview.
- Tap the image. If it is drawn artwork standing in for a photo, the dock shows "Replace image".
- Press "Replace image". It opens the product's page when the artwork stands for a product; otherwise it opens Settings, then General, where the "Landing image" card is.
"Replace image" shows on drawn artwork only. For a photo that is already in your store, go to where it is set, below.
Product photos
Open Products, then the product, change its photos under "Images", and press "Save" on the page. A product photo is live as soon as you save, with no publish. The article on product photos covers adding, ordering and editing them.
Landing image and logo
- Open Settings, then General.
- On the "Landing image" card press "Upload an image", or "Replace image" if one is there. On the "Logo" card the buttons are "Upload a logo" and "Replace logo".
- Pick the file. It saves on its own ("Landing image saved." or "Logo saved.").
"Remove" takes the image away: the landing page goes back to the artwork your store was built with, and the store shows its name in text instead of a logo. A wide photo works best for the landing image, and a wide mark for the logo.
Accepted files
- Formats: PNG, JPG, WEBP, GIF or AVIF.
- Size: up to 5 MB per file.
- The same rules apply to product photos, the landing image and the logo.
What happens to the old image
The new image takes the old one's place in your store, and the old one stops showing. A product photo you remove leaves that product only: if it is also on another product, a collection or a page, it stays there. We keep no list of earlier landing images or logos, so keep your own copy if you might want one back.
On a store published before the logo and landing image features, the card says "Your logo is saved, but your published store predates this feature: republish it to make the mark show." (or the same about the image). Publish your store again and it shows. On every other published store both are live as soon as they save, with no publish.
If it does not work
- "That file is too big.": the file is over 5 MB. Make it smaller and upload it again.
- "That isn't an image we can use.": save it as PNG, JPG, WEBP, GIF or AVIF.
- "Uploads are down right now. Try again shortly.": try again in a few minutes.
- No "Replace image" after you tap a picture: it is a real photo, not drawn artwork. Change it on the product, or in Settings, then General.